IRIG-B TTL to RS485 Converter

IRIG-B TTL to RS485 Converter

The IRIG-B TTL signal is a time synchronization protocol that can be transmitted up to 50m maximum using coaxial cable. So the relay which is to be received the IRIG-B TTL signal may be far away from the IRIG-B source. The relay may be not able to synchronize with the GPS. To avoid such an incident in the field, some of the relays have provision to receive IRIG-B RS485 signal. The IRIG-B RS485 signal can able travel up to 1200m without any booster. All Time source equipment may not be supplied with IRIG-B RS485 signal output. The converter will act as a bridge between GPS Time source and Relays for time synchronization.

SLC-1010 series converter is used to convert the IRIG-B TTL to IRIG-B RS485 signal. It provides easy and affordable connectivity to substation equipment and power generation and distribution equipment. It converts the IRIG-B TTL input format like 002, 004, 006 & IEEE1344 and IEEE C37.118 to RS485 output with the same format. With these Plug-N-Play units, you can expand your IRIG-B TTL signal to a long distance. The converter supports 2-wire RS-485. It can able to support a minimum of 32 nodes or 128 nodes (1/4 UL) based on unit load. It is rugged and surge-protected equipment. Its cabinet can be mounted directly on a wall without the need for additional brackets. It has an inbuilt power supply module, therefore, doing away with the need for an external power adapter. It consists of a BNC connector for IRIG-B TTL input and a terminal block for IRIG-B RS485 outputs. There is a LED indication for Power & signal outputs. The power supply can be customized when ordering.

Category: .

Features

  • Converts the IRIG-B TTL to IRIG-B RS485 signal
  • Industrial grade enclosed in a rugged, rustless housing
  • Wall mountable
  • RS485 signal can be transmitted up to 1200m
  • LED indications for Power & signal outputs
  • The supply voltage can be customized
  • Built-in surge protection and static protection
  • Built-in 120-ohm termination resistor

Applications

  • Substation
  • Power Generation and Distribution plant

Specifications

Power Supply
Standard 85 to 260V AC, 1φ, (47Hz to 63Hz) or
90V to 370V DC
Custom 24VDC or 48VDC
Power Consumption <5W
Input Signal
IRIG-B (PWM/TTL) Logic 0 :0V +250mV
Logic 1 :3V to 5V +10%
Connector BNC, Female
User Interface
Status LED Signal & Power
Environment
Operating Temp 0°to 50°C
Humidity 95% Non-Condensing
Mechanical
Installation Wall Mountable
Dimension 40mm (H) x 100mm (W) x 135mm (D) ± 5mm
Weight <250g
Protection Class IP20
Output Signal
Output IRIG-B RS485
Distance 1200m
Number of Output 1
Connector Pluggable Terminal Block, 120Ω

Catalog